8960 W下待机功耗测试配置讨论

我们目前测试W下待机功耗是修改Cell parameters下的不连续接收周期时间为256frames，这个不太理解，为什么只选择256frames（64/128/256/512frames），另外，寻呼时间系数不是从3~9可以选择吗，这两者之间是如何换算的，2G待机功耗测试选择2~9不同的接收周期时间测试，求大神指教，谢谢！

不懂，mark下，等大神来解答！

RD_DG_09_v51 Battery Life Measurement   这个文档有详细的介绍   DRX  7
Parameter        Recommended Value        Comment
Serving Cell UARFCN (downlink)        Band I: Mid Range
Band II: Mid Range
Band III: Mid Range
Band IV: Mid Range
Band V: Mid Range
Band VI: Mid Range
Band VII: Mid Range
Band VIII: Mid Range
Band IX: Mid Range        All bands supported by the handset must be measured.
Results must indicate which band(s) have been measured, and individual result for each band
Number of neighbours declared in the BA_LIST        16        See Note
Neighbour cells on different frequency        No       
Serving Cell Scrambling Code        Any        Used value shall be reported with the test results
Neighbour cell scrambling codes        Any        See Note. Used values shall be reported with the test results
Paging Interval        1.28 seconds (DRX 7)        This value must be used unless operator requests 2.56 s (DRX 8).
Periodic location updates        No        T3212 = 0
CPICH_RSCP (Ec)        -97 dBm        This level is typically seen on network serving cells
Serving cell code power (DPCH_Ec/Ior)        -5 dB        This level is measured as an offset from channel power
Ec/No        > 12 dB       
SIntrasearch        Not applicable        This parameter shall not be sent. Refer to [8] section 5.2.6.1.1
SsearchRAT        Not applicable        This parameter shall not be sent. Refer to [8] section 5.2.6.1.1
Table 3.3: WCDMA parameters for Standby Time
Note: although the mobile is required to monitor these neighbour cells, the test equipment does not in fact provide signals. It is explicitly stated in [1] that no signals should be present on the neighbour frequencies. If signals are present then the handset will attempt to synchronise and this is not part of the test.

多谢，我看看~